LXE MX3, Руководство пользователя

Страница: 17 / 64

Optional Devices 11
E-EQ-MX3RFIDOGWW-A MX3-RFID User’s Guide
Connecting the Audio Jack (Optional)
The audio jack is located on the endcap.
Figure 12 Connect Audio Jack
Insert the 2.5mm barrel end of the connector into the audio jack on the endcap and push the
connector in firmly. See section titled “Set the Audio Speaker Volume”.
Note: The audio option draws power from the battery. The speaker is disabled when a headset
is plugged into the audio jack.
Attaching the Stylus Clip (Optional)
Carefully remove the paper backing from the Stylus Clip sticky. Firmly press the sticky side of the
clip onto the mobile device and hold in place for 15 seconds. Thread the tether through the end of
the stylus and tie the ends firmly to the Stylus Clip so that the ends don’t interfere with placing the
stylus in the Stylus Clip. Place the stylus in the Stylus Clip when not in use.
An extra stylus or replacements can be ordered from LXE. See the section titled “Accessories” for
the stylus part number.
Applying the Protective Film to the Display (Optional)
First, clean the display of fingerprints, lint particles, dust and smudges.
Remove the protective film from it’s container. Remove any protective backing from the film
sheet by lifting the backing from a corner of the film. Discard the backing.
Apply the film to the screen starting at one side and smoothing it across the display. If air bubbles
appear, raise the film slightly and continue smoothing the film across the display until it covers the
glass surface of the display.
If dust, lint or smudges are trapped between the protective film and the glass display, remove the
protective film, clean the display and apply the protective film again.