13
• Rotate the brass shaft sleeve to make the angle of the red mark and the
illumination arm between 30º - 90º
• Loosen the screw in the illumination arm with the screwdriver (R). Aim the
assembly hole of the illumination arm at the brass shaft sleeve then put it
down with care, let the shaft keeping close to the bottom surface well and
the two red marks stretch in one line simultaneously.
• After the two red marks accurately aligned re-tighten the screw.
6.
Assembling the breath shield ( E )
• Remove the breath shield fixation screw from the microscope arm.
• Pass the removed screw trough the hole of the breath shield then re-screw
it into the arm.
7.
Connecting Plug
• Peel of the sticky tape attached to the cap, which ensures that the cap is
tightened to the lamp base during transportation.
Microscope
arm
Fixation screw
Breath shield
