User Guide
14
© Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
connect the opposite end of the Ethernet cable to which the access point is
already connected to the provided POE injector or other POE switch or injector. An
Ethernet cable length of up to 300 feet can be used. DO NOT yet apply power to
the POE injector or switch.
NOTE:
Category-5, super Category-5 or Category-6 unshielded twisted pair
(CAT5/CAT5e/CAT6 UTP) cables should be used. For best results, it
is recommended that CAT5e or CAT6 shielded twisted pair be used
to ensure stable data transmission at highest data rates.
4.4.4 Connecting to the Internet Source
The Luxul device is not a router and in most installations will be connected to a
Router or Switch in order to deliver Internet access. To do so, connect the POE
injector (or switch) to the desired Internet source using another Ethernet cable. Be
sure the source device is powered off.
POE
Injector
Power
Source
Power
In
Ferrite Noise
Suppresser
Data
Source
Poe
Device
Data/Pwr
Out
Data
In
The POE Injector Sends Power and Signal Over One Ethernet Cable
4.4.5 Applying Power
Once the Ethernet cables have been properly connected, connect the power sup-
ply to the POE injector and plug it in to a standard AC power outlet. Or, if plugging
into a POE switch, turn the switch (or appropriate port) on. The network source
device can also now be powered back on.
NOTE:
If your Internet source (Router or Switch) is a POE enabled device
and connected via POE, it can be plugged directly into the access
point without the need to run a separate POE injector.
4.4.6 LED Visual Verifi cation
With power applied, you can now verify that the XAP-1010 is connected and
functioning properly. Prior to placing the access point cover plate, perform a visual
