QuiCK inStALL guide
Poe (Power over ethernet) (Figure 2)
1. Connect the Ethernet cable from your data/network
source to the “48V POE IN” port of the Wi-Fi Signal
Booster.
2. Connect the next Ethernet cable from the “POE OUT”
of the Wi-Fi Signal Booster to the “10/100M” port of
your Netgear AP, (See AP’s documentation).
3. Be sure all cables are connected securely and power
up your POE injector.
4. You may now power your POE injector.
Poe with the Poe-1Port Injector (Figure 3)
Install the POE injector where you have access to your
data/network source Ethernet cable and power sources.
Note:
The POE-1Port is a non
802.3af/at compliant injector
direct Power: (Figure 4)
Note:
If powering the Shock-WAV
Signal Booster directly the
“POE OUT” port is disabled.
1. Connect the Ethernet cable from your data/network
source to the “10/100M” port of your Netgear AP,
(See AP’s documentation).
2. Attach the Luxul power supply (48VDC) to the “48V DC
IN” port
of the Signal Booster.
3. Connect Netgear power supply to the AP’s power
port (See AP’s documentation).
4. Plug the power supplies into your power source.
FIGURE 4
Data
Source
Power
Source
Data
In
(Ethernet)
Power
In
Data/Pwr
Out
(Ethernet)
POE-
1port
Injector
INPUT
ANTENNA
OUTDOOR
INDOOR
POE
OUT
POE
IN
48V
DC IN
ETHERNET
POWER
Coax 195
Coax 400
INPUT
ANTENNA
OUTDOOR
INDOOR
POE
OUT
POE
IN
48V
DC IN
ETHERNET
POWER
Coax 195
Coax 400
FIGURE 2
FIGURE 3
