QuiCK inStALL guide
AssEMbLE ThE RAnGE ExTEnDER KIT
1. Position the X-WAV antenna outdoors so that it points towards the desired
coverage area
2. Feed the WBC™-400 Coax cable (the thicker coax) through the wall to your
buildings interior where the signal booster and AP will be located.
ConnECTInG ThE CoAx CAbLEs
1. Connect the X-WAV antenna to the Shock-
WAV Wi-Fi Signal Booster using the N-Male to
N-Male cable. Be sure to connect the cable to
the side of the Shock-WAV Wi-Fi Signal Booster
labeled “Antenna”.
2. Remove the stock antenna from your AP. Set
aside the stock antenna, you will not need it for
this installation.
3. Using the included N-Male to RP-SMA cable
connect the Shock-WAV Wi-Fi Signal Booster to
the antenna port of your AP. Be sure to connect
the cable to the side of the Shock-WAV Wi-Fi
Signal Booster labeled “INPUT”.
PoWERInG oPTIons
For maximum flexibility you may power the Pro-WAV Outdoor Range Extender/Bridge
Kit by Direct Power or POE using the Luxul Wireless POE Injector or a POE injector that
supports legacy mode. The Luxul Wireless Signal Booster does not support 802.3af POE
power. (Check POE’s documentation).
FIGURE 1
INPUT
ANTENNA
OUTDOOR
INDOOR
POE
OUT
POE
IN
48V
DC IN
