Luxier
SP06-CEC Rev. A 102019
7
1. Remove existing shower head and shower arm.
2. Connect the 3” brass nipple to the water pipe inside
the wall. Leaving about 1” of the connector outside
the wall.
(
NOTE:
Apply PTFE tape on both end of the
connector.)
(
IMPORTANT:
Insert the brass nipple with flow
restricting device end first into the wall. Failuare
to follow this step will result in no water flow to the
shower panel. See figure A)
Teflon (PTFE) Tape
To Wall
To Shower Panel
white plastic restrictor
Figure A
Installation
1
2
3
4
5
3. Install hand shower cradle (1) to the shower panel
by installing the rubber washer (2) and the locking nut
(3) and attach white plastic hose tube connector (5)
with PVC tubing to complete the connection.
(
NOTE:
Make sure the silicon gasket (4) is seated
properly inside the connector.)
