Luxier
SP06-CEC Rev. A 102019
9
Installation (cont.)
8. Measure the length needed for the main water
supply hoses. Trim off the excess PVC tubing.
9. After the excess hose has been trimmed. First slip
hose clamp (B) onto the PVC hose (C). Insert the
elbow connector (A) into the hose. Push the hose
(B) up toward the end of the hose. Tighten the hose
clamp (B)
(
NOTE:
Do not over tighten the clamp)
A
B
C
10. Wipe the surrounding surface around the pipe free
of dirt and debris. Peel off the adhesive backing of the
cover base (A) and press it firmly against the wall to
ensure a tight bond. Apply some PTFE tape on the
pipe threading. Connect the main water supply hose
assembly to the pipe.
(
NOTE:
Do not over tighten the nut as it may damage
the seal and causes leaks) Once the connection is
made, install the cover over the elbow connector.
A
B
11. Connect hand shower hose to the main panel
body and connect the hand shower wand to the hose.
Make sure the silicon gaskets are seated properly
to prevent water leak. Run water to the unit for few
minutes and check for leaks at all connections.
