5
Wire 4-pin terminal block
5.1
Strip 2 in (50 mm) of the jacket
off the cable run from the wall.
5.2
Wire the 4-pin terminal block (provided) to the cable using a screwdriver.
Make sure to tighten the screws tightly and that no insulation is inside of the
terminal block.
Notes:
•
The EDU connector will support wire sizes from 12 AWG (2.5 mm²) to
26 AWG (0.2 mm²). See the instruction sheet for your power supply
to choose an appropriate wire size for your application.
•
Strip insulation from wires so that 0.25 in (6 mm) of bare wire is exposed.
MUX (Pin 4)
MUX (Pin 3)
24 V (Pin 2)
Common (Pin 1)
}
To EDU
Connector
Page 9
Sivoia
®
QS
roller 100
TM
Pocket Mount
Installation instructions
