Page
27
of
60
No.
Problem
Solution
1.
The main cable is not
threaded into the vertical
stand.
Take the main cable and thread it into the hole located
at the top of the vertical tube. Feed it through the pole
until you can pull it out from the hole located on the
bottom of the vertical tube. It doesn’t matter which end
you thread into the hole. Connectors on both ends are
identical.
Diagram 2.6.1-1
2.
The power box is not
attached to the vertical
tube.
There should be 2 power box assembly rings and 4
screws. Each ring is a semi-circle.
Diagram 2.6.1-2
The rest of the ring is already attached to the power
box.
Diagram 2.6.1-3
Take the power box and place it on the vertical stand
on the opposite side as the extension knob. Place it in
the space between the hole on the bottom of the tube
and the extension knob (approximately 3-4 inches
above the top of the hole).
