46 Betty
47
Betty
En
gl
is
h
Problem
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The Power LEDs do not stay on
for as long as they should.
Battery cannot be charged:
Charger One does not respond
when a battery is connected to
it and does not begin charging,
i.e. the display only shows
“Ready for charge.”
Cause
Extremely discharged battery.
Battery not plugged into the
light or not plugged in
properly.
Faulty LED unit.
Discharged battery.
Old battery.
Very low ambient
temperature.
Faulty charger.
Unsuitable battery.
The battery’s internal elec-
tronics blocked further
discharge by shutting down.
It will take the connected
Charger One a few minutes
to initialize and begin
charging.
Solution
Charge the battery. Before
doing so be SURE to read
the “Battery cannot be
charged” section below.
Check all plug contacts.
Replace the LED unit.
Charge battery.
Replace battery.
Keep battery warm.
Replace charger.
Use original Lupine battery.
Leave the battery connected
to the charger and wait.
This process can take up to
an hour.
Normally the plug contacts are maintenance free. However, if you use your Betty light in humid, salt-
air, environments, it’s advisable to apply a thin layer of
Lupine Dutch Grease
to the contacts every so
often to prevent oxidation.
Do NOT use terminal grease or contact spray.
Important:
Always keep the battery separate from the Betty light,
because otherwise the small
amount of power used by the electronics will discharge the battery, and the lamp may switch on
accidently.
Important!
Moreover, the consequent uncontrolled heat buildup could cause a fire or
melt the adjacent plastic material. Could cause fire or death!
During lengthy periods of non-use, fully charge the battery and store it in a cool, dry place, base-
ment or the like. The battery can be kept plugged into the charger if desired. For further information
concerning battery care and the battery’s professional 50 % LI storage function, consult the charger
manual.
Open the light housing’s front screw-on cover. Grasp the rear section of the lamp with one hand while
rotating the front section of the cover to the left (counterclockwise) with the other hand. Once you
have removed the cover, you will see the 7-array lens. Do not touch it.
Check to ensure that the O-ring on the rear section of the housing is correctly positioned.
The housing will only be waterproof if its O-ring is intact. After completing this inspection, carefully
screw down the housing cover.
Important note:
if the thread runs smooth, the cap is in the right
position. Otherwise please stop and screw back the cover and try again, otherwise you might
damage the thread.
Plug contacts:
Transport:
Storage:
Opening the light housing:
Closing the lamp housing:
Product care and storage
Troubleshooting
7
8
