42 Betty
43
Betty
En
gl
is
h
5
5
Programming the PCS
SOS function:
Int. SOS emergency signal
Alpine emergency signal
Superflash
1. Keep calm
2. Read this section and the programming table
3. Determine
ahead
of time which steps you need to take to reach your goal. Whether these steps
are correct is indicated by the order in which the various LEDs are illuminated. It is advisable to
note down this order ahead of time so that everything goes according to plan.
When the desired LED color and the attendant option is reached,
release the button,
which takes
you to
level 2.
Here, you define the performance characteristics for the selected option.
Going through the options at this level makes the PCS run automatically,
a state that is signaled by
a continuously illuminated LED in a specific color.
In other words,
release the button,
simply wait until the LED in the desired color comes on, and
THEN press the button again
to confirm your selection and exit automatic programming mode.
And that’s it for level 2.
Now proceed to level 3 – but of course only if you wish to activate two or three level dimming (low
beam) and have pressed the button for the relevant LED in
level 2. Level 3
only enables you to defi-
ne dimming intensity. The PCS programming options at this level likewise run automatically. After
the button has been released again, the LED (which now lights up) allows you to select the desired
dimming level, i.e. 4 %, 12 %, 38 % or 58 %. To do this, again press the button when the LED showing
the desired percentage is displayed. And now you’re done.
Low beam/dimming:
three-level (superflash)
two-level
three-level
stepless
Battery warning signal:
Low
Middle
High
Power management:
Economy
Normal
Power
The Support section of our Website contains a series of videos that show you how to
program the PCS.
Note:
Always program the PCS with the light plugged into the battery.
At
level 1,
which shows you the various programming options, select the function you’d like
to program:
Low/high beam
Battery warning signal
Power management
SOS function
Level 1
runs from left to right if the button is held down
continuously,
and the LEDs come on
in alternation at
four second
intervals or so.
Helpful hint:
To familiarize yourself with the programming procedure, it’s best
to
start with stepless dimming
and then move on to two-phase dimming.
The three-phase dimming program is for advanced users only.
Default setting
Tips for inexperienced programmers:
Programming flowchart:
