24
U.L. Model No.: CF205L-1
8. Remote Control Procedures
(Continued)
8.7: Storage Bracket Installation
A Storage Bracket is provided for holding your Remote
Control when not in use. If you desire to use the Bracket,
install it on a Wall that is away from excess heat or
humidity.
Slide the Wall Bracket Cover up to expose the Screw
Holes for installation (Figure 40).
Position the Bracket on the Wall in desired location.
TO INSTALL BRACKET TO
WALL:
SLIDE THE COVER UP TO
EXPOSE THE SCREW
HOLES FOR INSTALLATION
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 40
8.8
Install the Two Screws (provided with bracket) into the
Wall Bracket and tighten to secure to Wall (Figure 41).
Slide the Wall Bracket Cover back down over the Screws.
TO INSTALL BRACKET
TO WALL:
INSTALL THE TWO SCREWS
SLIDE THE COVER DOWN
WALL
BRACKET
SCREWS (2)
COVER
Figure 41
8.6
The Light Push Button ( ) turns the Light ON and
OFF and controls the Light Intensity (Figure 39).
To vary the intensity of the Light, hold the
Light Button ( ) down until the desired Light Intensity
is reached, then release the Button (Figure 39).
NOTE: When turning the light on, light will turn on
at the light intensity previously selected.
Your Remote Control has full control of your Fan and
Light.
The Power Indicator Light (blue glow) will Illuminate
while any Button is pressed, indicating that the Battery
is good.
POWER INDICATOR
LIGHT
LIGHT BUTTON
Figure 39
