22
U.L. Model No.: CF205L-1
8. Remote Control Procedures
Fan installation must be completed, including the
installation of the fan blades, before testing the remote
control.
WARNING
!
8.3: Setting Operating
Frequency of Remote Control
Remove the Battery Cover by pressing firmly below
the arrow and sliding the Cover off the Control
(Figure 36).
Your Remote Control has Code Switches which must
be set in one of 32 possible code combinations.
The five levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position. Change
the Switch settings as follows:
Slide the five Switch Levers in the Remote Control to your
choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the Levers firmly up or
down (Figure 36).
The sixth Switch marked ON and I is for dimming control
of lights: Set Switch to ON to allow for dimming of the
lights. Set Switch to I for no dimming of the lights.
NOTE: If your Fan and Light go on and off without
using your Control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems.
To remedy this situations, simply change the
combination code in your Remote Control
Transmitter.
CODE
SWITCHES
REMOTE CONTROL
BATTERY
COMPARTMENT
COVER
REMOTE CONTROL
LEVERS
ON
1 2 3 4 5
I
Figure 36
Your Receiver is equipped with a preset memory feature.
If the AC supply to the Receiver is powered through a
Wall Switch, when the Switch is turned OFF, the Control
will remember the Light Intensity and Fan Speed.
When the Switch is turned back ON the Light and Fan
will resume operation as they were prior to the Switch
being turned OFF.
8.1: Preset Memory Feature
Your Ceiling Fan consists of a Hand-Held Remote
Control Transmitter and a Receiver which is mounted
under the Fan Ceiling Cover.
8.2: Installation of Batteries
The Remote Control Transmitter is powered by two AAA
Alkaline Batteries (not included).
To prevent possible battery leakage damage, be sure to
remove the Batteries when the Control is not to be used
for an extended period of time.
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Remote Control.
Install two new AAA Alkaline Batteries into the Battery
Compartment following the correct Battery placement
printed on the Compartment (Figure 35).
NOTE: Never use old and new Batteries together in
unit.
REMOTE CONTROL
BATTERY
COMPARTMENT
COVER
TWO AAA
BATTERIES
Figure 35
Replace the Battery Compartment cover by sliding the
Cover back onto the Remote Control.
