7 CAPELLA COURT, OTTAWA, ON K2E 8A7, CANADA | TEL (613) 736-4077 | FAX (613) 736-4071 | WWW.LUMENERA.COM | [email protected]
© 2017 Lumenera Corporation. All rights reserved.
Design, features, and specifications are subject to change without notice
34
09282017
WWW.LUMENERA.COM
Lumenera Camera User's Manual
Release 6.8.1
None of the signals can supply much current. Maximum current draw should be kept to less than 24 mA.
For all GPO pins, the voltage swing is as follows:
For a LOW value: 0.0 to 0.1 V
For a HIGH value: 3.0 to 3.3 V
For all GPI pins, the tolerated input voltage swing is as follows:
For LOW input voltages: 0.0 to 0.5 V
For HIGH input voltages: 2.0 to 5.0 V
3.6.2
LuCam Large Format LW1X05X Camera GPI/O Interface Description
For Large Format cameras, the GPI/O port is located on the back of the camera just above the USB and power supply
connectors. This port uses a DIN connector from CUI, part number MD-80. It is also available from Digikey,
www.digikey.com, Digikey part number CP-2080-ND. The pin numbering is shown in Figure 27 and Table 8 defines the
pin-out definition.
Figure 27: Large Format Camera External Header Location and Pin Numbering
3.6.2.1
Header Pin-out
SIGNAL
PIN #
GND
1
GPO1 / Strobe Out (AL)
2
GPO2 / Strobe Out (AH)
3
GPO3
4
GPO4 / Video SOF
5
GPI1 / Trigger In
6
GPI2
7
GPI3
8
Table 8: Large Format Camera External Header Pin-out Definition
