7 CAPELLA COURT, OTTAWA, ON K2E 8A7, CANADA | TEL (613) 736-4077 | FAX (613) 736-4071 | WWW.LUMENERA.COM | [email protected]
© 2017 Lumenera Corporation. All rights reserved.
Design, features, and specifications are subject to change without notice
25
09282017
WWW.LUMENERA.COM
Lumenera Camera User's Manual
Release 6.8.1
The
Hide Capture
button will close the snapshot image display window.
The
Wait for HW Input Trigger
toggle is used to specify that the snapshot should be hardware (HW) triggered using the
HW
trigger input of the camera’s external header. With this option selected, when the Snapshot button is pressed, the
software will pause as the camera waits for the HW trigger before returning the image. There is a built-in time-out of 25
seconds after which time if the HW trigger has not occurred, the software will resume operation.
The
Use Strobe Trigger
toggle is used to specify that during the snapshot exposure, the strobe trigger output should be
fired.
The
Strobe Delay
value indicates the time in milliseconds between the rising edge of strobe output and the rising edge
of the strobe trigger pulse.
The
Save As
button is used to save the snapshot image to disk in one of the available formats.
The
16-Bits per Pixel
toggles the camera between 8 and 16-bit data mode for snapshot capture.
The
White Balance Gains for Strobe Snapshot
values allow you to set the Red, Green and Blue gains to be used
during the snapshot capture. This allows you to white balance according to the strobe lighting that is being used. They
are only applied if the Use Strobe Trigger option is selected.
