Lumberjack PS240, Инструкция по безопасности и эксплуатации

Страница: 8 / 17

PS240 06
ASSEMBLY INSTRUCTIONS
Assembly
Avoid unintentional starting of the machine.
During assembly and for all work on the
machine, the power plug must not be
connected to the mains supply.
Carefully remove all parts included in the
delivery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed in the box
content section have been supplied
Note: Check the power tool for possible damage.
Before further use of the machine, check that all
protective devices are fully functional. Any
lightly damaged parts must be carefully checked
to ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Assembling the Dust Extraction System
Slide the dust collection box(9) onto the Dust
extraction outlet(4).
To remove the dust collection box pull away
from the sander.
Caution: Always wear a suitable breathing mask
when operating this tool. All wood and paint
dust is hazardous to health and may also be
toxic.
Installing Sanding Sheets
Note: To maximize the quality of the task,always
use good quality sanding sheets. Always test the
sander on a scrap piece of material to determine
whether the sanding sheet is suitable for the
intended task:
Coarse for use sanding bare wood in preparation
for finishing, gentle removal of varnish.
Medium for sanding bare wood in preparation for
finishing not suitable for the removal of varnish.
Fine for sanding finishes in-between coats.
Important DO not use sanding sheets designed for
wet sanding.
Fitting the sheets
To install fresh sheet of sandpaper, lift the Lever(8)
over the tab. This will lift the paper clamp(5).
Insert one end of the new sandpaper sheet under
the paper clamp and lift the lever back into place
over the tab.