Lumberjack PS240, Инструкция по безопасности и эксплуатации

Страница: 11 / 17

CAUTION: Never use caustic agents to clean
plastic parts. If dry cleaning is not
sufficient, using a mild detergent on a
damp cloth is recommended.
WARNING! Do not allow the tool to come
into contact with water or any other liquid.
Ensure the tool is thoroughly dry before
using it. If available, use clean, dry,
compressed air to blow through the
ventilation holes(where applicable).
Surfaces need to be clean, free of dirt and
foresight matter(hair, sand etc.) and in
good condition.
PS240 09
MAINTENANCE AND SERVICE
Maintenance and Service
Maintenance and Cleaning
Before any work on the dust collector itself, pull
themains plug.
For safe and proper working, always keep the
dust collector and ventilation slots clean.
If the replacement of the supply cord is
necessary, this has tobe done by an authorized
service agent in order to avoid a safety hazard.
If the dust collector should fail despite the care
taken inmanufacturing and testing procedures,
repair should be carriedout by an authorised
service centre.
General inspection
Regularly check that all the screws are tight as
they may vibrate and loosen over time.
Inspect the power cable(3) prior to each use for
damage or wear.
Repairs should only be carried out by a qualified
technician.
Keep your tool clean at all times. Dirt and dust
will cause internal parts to wear quickly and
shorten the tool’s service life. Clean the body of
the tool with a soft brush or dry cloth.
We recommend using compressed air when
possible to clean down the sander. This aids the
products longevity.