Section 1 – Getting Started
RadianceXD
Rev 1.0
2
Document Conventions and Menu Navigation
Commands are selected with the supplied infrared remote or the RS232 serial port. To prevent possible
command conflict, only one of these methods of command should be used at a time.
The infrared remote control command notation is described below:
•
Remote buttons are named as shown on the remote in a bold font.
Example:
MENU
.
•
For comma separated lists, press the buttons in the sequence shown.
•
For parenthesized lists, select one button from the list.
•
For square-bracketed lists, press the buttons as needed.
Example: For the list [ , , , ], press the arrow keys as needed.
•
For menu commands press the
MENU
button. The and arrow keys are used to select the
function. The arrow key (or OK) is used to enter sub-menus. This is shown as:
MENU
→
MenuItem
→
MenuItem.
The arrow key (or
EXIT
) steps up one menu level.
•
Numerical entries are listed as
value
. While entering the value, the arrow key acts as a
backspace key.
•
Some commands are activated immediately. Other commands must be explicitly accepted by
pressing
OK
. If needed,
OK
is listed as part of the command.
•
Pressing
EXIT
cancels a partially completed command. If the menu system is active,
EXIT
returns
to one level higher in the menu system.
•
There are four independent configuration memory types for each input (
MEMA
,
MEMB
,
MEMC
and
MEMD
). The input setup and output resolution/timing can be set independently for each
memory. Note that, initially, there is a single output mode for all configuration memories. To
program an input memory, first select the input, then select the desired configuration memory
and use the menu system to configure.
•
Some menu commands are only available when their associated input is selected.
•
Before changes are saved, they can be discarded by entering standby (
STBY
) mode.
•
To prevent unintended configuration changes, before saving, use the
Lock
command.
•
Save the configuration after making changes, otherwise the changes will be lost when entering
STBY
mode.
If the serial port is used, the ASCII character associated with the respective remote control button must be
sent. See the Serial RS232 Command Interface section for information on serial commands.
Unpacking
•
Unpack the box.
•
Make sure that you remove all of the accessories from the packing.
•
Save the box and packing materials in case you need to ship your RadianceXD.
Check the Components
Verify that your box contains the following items:
•
Lumagen RadianceXD video processor
•
Universal power-supply, INPUT: 100-240V~50/60Hz
•
Remote control
•
AAA Batteries (2)
•
RadianceXD Owner’s Manual
•
RS232 Null-modem cable
•
Warranty card
