Section 5 – Configuration
RadianceXD
Rev 1.0
22
Sidebar Pan
To help reduce screen burn-in with 4:3 sources on widescreen displays, the output can be slowly moved left and
right a fractional pixel step every few minutes. The command is:
MENU 0 9 8 7
Toggle Sidebar-pan for anti-burn. Default = off.
Saving the Configuration
Save
NOTE:
If a save command is not executed, any changes will be lost when the unit is put into
standby power mode, or if power is interrupted.
Permanently save the current configuration. Note that, once saved, the configuration is retained even if the unit is
disconnected from power. The configuration from the previous save is retained to allow one level of save-undo.
The command format is:
MENU
→
Save
→
Save
→
OK
Save Undo
Revert to the configuration over-written by the last save. Repeating the save undo command toggles between the
last two saved configurations. The command format is:
MENU
→
Save
→
Undo
→
OK
Revert To Factory Settings
Set all parameters to factory defaults. A
SAVE
is required to make permanent. The command is:
MENU 0 9 9 9
Or
MENU
→
Save
→
Factory
→
OK
Restore Configuration Saved during calibration
During calibration, the video technician can save the resulting Lumagen configuration to a special hidden
configuration memory. This command restores that configuration in the event that the user inadvertently changes
the configuration. A
SAVE
is required to make the restore permanent. The command format is:
MENU
→
SAVE
→
Restore
→
OK
Revert To Defaults For Current Output Resolution
Set output parameters to defaults for the current output resolution. A
SAVE
is required to make the default
parameters permanent. The command is:
MENU 0 9 9 8
Or
MENU
→
SAVE
→
Factory
→
OK
Picture Controls
Color and Hue
NOTE: Set the display’s Color and Hue to their default values.
Use the
Advanced AVIA
®
color test pattern to set Color and Hue (
Advanced AVIA
→
Video Test Patterns
→
Color
).
Follow instructions on the
AVIA
disc. Calibrate using the blue color bars and blue filter (
COLR
and
HUE
).
Then calibrate using the red color bar image and red filter (
COLRED
for
HUERED
), and then the green color bar
image and green filter (
COLGRN
and
HUEGRN
).
The command format is:
MENU
→
Input
→
Video Setup
→
[Resolution]
→
Picture
→
Color/Hue
→
(
Color Offset
,
Hue Offset
,
Color Red
,
Hue Red
,
Color Green
,
Hue Green
)
→
Ok
