30
31
Notes:
• Some areas of skin are darker than
others. You must use the SKIN TONE
SENSOR on each different area you
want to treat.
• If you feel the SKIN TONE SENSOR
has not made a proper reading, you
may try again after 5 seconds. If you
believe your skin is suitable based
on the Skin Tone chart on page 15
but the SKIN TONE SENSOR will not
enable the device, contact Customer
Service (see page 51).
• If you have tanned skin in the intended
treatment area, DO NOT use the
LumaRx Full-Body Hair Removal
System in those areas as your skin may
be too dark for treatment. You should
wait until your tan has completely faded
from any intended treatment area
before using the LumaRx Full-Body
Hair Removal System.
2c.
Place the body part to be treated over
the SKIN TONE SENSOR (touching the
unit) the Sensor will immediately read
the skin type.
2e.
If your Skin Tone is suitable for use,
a high-pitched “BEEP” will sound
and the SKIN TONE SENSOR will turn
green and the device is ready for use.
2d.
If your Skin Tone is NOT suitable for
use, the SKIN TONE SENSOR turns solid
YELLOW and the device will “BUZZ”
once for 5 seconds. After 5 seconds,
you may re-try the SKIN TONE SENSOR
(step 1 above).
2f.
Once the device is enabled, the
ENERGY LEVEL LIGHT and BULB LIFE
LIGHT will turn on and the internal fan
will start. Your LumaRx Full-Body Hair
Removal System is set to the lowest
energy level setting and ready for use!
STEP 3: SELECT ENERGY LEVEL
Energy Level Indicator Lights determine
the intensity of the LumaRx Full-Body
Hair Removal System light flash
delivered to your skin, from the lowest
level (*) to the highest level (*****).
Higher levels improve hair removal
results, but may be less comfortable.
To get the best results, you should use
the highest setting that’s comfortable.
There are 5 energy level settings on the
LumaRx Full-Body Hair Removal System.
Whenever the device is turned on, it is
automatically set to the lowest energy level
and only 1 ENERGY LEVEL INDICATOR
LIGHT will be on (ENERGY LEVEL 1 in the
table below). To modify the energy level,
press the ENERGY LEVEL SETTING BUTTON
to increase the energy level. Once the
energy level has reached level 5, pressing
the ENERGY LEVEL SETTING BUTTON will
return the device to energy level 1. The
number of ENERGY LEVEL INDICATOR
LIGHTS will coincide with the change in
energy level. See Figure 3 on page 32.
OPERATING INSTRUCTIONS
