LUMA RX IPL6800USA, Инструкция по использованию и уходу

Страница: 14 / 30

26 27
OPERATING INSTRUCTIONS
Once you’ve become familiar with
the LumaRx Full-Body Hair Removal
System and read all the information
on the preceding pages, including the
WARNINGS and PRECAUTIONS, you’re
ready to use the LumaRx Full-Body Hair
Removal System.
This section explains step-by-step
how to operate the LumaRx Full-Body
Hair Removal System. Read this entire
section carefully before you start
treatment. Then refer back to it later as
you follow the steps.
The first time you use the LumaRx
Full-Body Hair Removal System, you
should test it on a small patch of skin.
See steps on pages 27-31.
Each time you use the LumaRx Full-
Body Hair Removal System, make sure
the Hand Piece, Flash Window, Skin
Contact Sensor, and Skin Tone Sensor
are clean and free of debris; clean
the system if necessary. Refer to the
User-Maintenance Instructions on
pages 39-43.
WHAT TO EXPECT
• If you have redness, blistering or
other skin irritation in the treatment
area, DO NOT perform treatment.
Wait until the skin returns to normal
before using the LumaRx Full-Body
Hair Removal System again. If the
irritation does not go away with 3
days, contact Customer Service on
page 51.
One to Two Weeks after the First
Treatment
• Hairs in the treated area will begin to
fall out gradually, but it is unlikely you
will notice significant reduction in hair
at this stage.
• Make sure to complete the full
treatment schedule to ensure you hit
all hairs in the growth phase in the
targeted area.
Two Weeks after the Last Treatment
• You should see a noticeable reduction
in hairs in the treated area. Also, any
new hair growth should be lighter
and finer.
• At this point, additional treatments on
the same area should only be done
as needed to target hairs that have
recently entered the active cycle.
You only need to use the LumaRx
Full-Body Hair Removal System
for occasional touch-ups, where
necessary, or to treat another area.
STEP 1: PREPARE SKIN
Before using the LumaRx Full-Body Hair
Removal System, prepare the treatment
area by thoroughly Cleaning, Shaving,
and Drying the intended treatment area.
It is important that you remove any
makeup from the treatment area.
Removing surface hair and cleaning the
skin helps to minimize the sensation
felt from the LumaRx Full-Body Hair
Removal System flashes and allows
the energy to penetrate to the hair root.
Because the LumaRx Full-Body Hair
Removal System works below the skin,
the device is still effective even if hairs
are not clearly visible.