Lucent Technologies PacketStar PSAX 8-Port Voice 2-Wire Station Module, Руководство пользователя

Страница: 69 / 100

255-700-261 6-5
PacketStar
®
8-Port Voice 2-Wire Station Module User Guide , Issue 1 Release 8.0.0
Chapter 6 Configuring Interfaces Using the AQueView
®
EMS
The Circuit Emulation Interface
Configuring Circuit Emulation Interface Values
To set the values for the Circuit Emulation interface, perform the steps in the
following procedure.
Begin
1 To configure the Local NSAP Address (Hex) field, perform the steps in
the section, “Adding NSAP Addresses,” in this chapter, and then return
to this procedure.
2 To apply the interface configuration values, including the NSAP address
configuration, click Apply.
End
Apply Applies the configuration field value you
set.
Reset Resets the fields to the last set of applied
values.
Button Function
Table 6-1. Field Descriptions for the Circuit Emulation Interface Configuration Window
Field Names Field Values Description
Interface Type Default: N/A
Range: N/A
Format: predefined
alphanumeric
Circuit Emulation displays as the interface type.
Signaling Default: CCS Clear
Channel signaling
Range: N/A
Format: predefined
alphanumeric
The type of signaling used.
Note:
This field is displayed only when configur-
ing the circuit emulation interface on these mod-
ules:
•
6-Port Multiserial
• 6-Port Enhanced DS1 Multiservice
• 1-Port Channelized DS3
CCS Clear Channel
signaling Clear channel signaling—ABCD signaling bits not
used.
CAS (channel-asso-
ciated signaling) Channel associated signaling—signaling bit trans-
port based on ATM Forum stardard for ABCD sig-
naling bits. ISDN requires the use of the whole
port. Will not function with CAS.