Lucent Technologies Definity Audix System, Установка и обновление

Страница: 45 / 208

Task 7: Install the Terminals
Issue 2 December 1996
2-23
e. Plug one end of a D8W cable into the LINE connector on the 7400B
data set and connect the other end into a telephone outlet.
f. Connect the 7400B power supply to the data set, and plug the
power supply into a wall outlet.
g. Plug the terminal power cord into a wall outlet and power on the
terminal.
h. Set the terminal options. Refer to Appendix B, ‘‘Option Settings’’, for
a complete list of option settings for all supported terminals.
NOTE:
When installing a serial printer on all but a 610 or 615 BCT, set
the options on the printer as described in the manual supplied
with the printer, then set the corresponding options on the
terminal to match. On the 610/615, set the terminal options
first, then set the printer options.
i. At the terminal, enter AT.
If the 7400B data set is connected correctly, it responds with “OK”
(on the terminal screen).
j. Enter ATDT and the phone number of the 7400A data set
connected to the DEFINITY AUDIX system (refer to the Terminals
worksheet for this number).
After a connect interval, if the terminal and 7400 data sets are
installed correctly (and the DEFINITY AUDIX system is in either
ADX , OAM , OS or AINIT state), the screen displays the login
prompt.
If login prompt is not displayed when the DEFINITY AUDIX system
is in one of the above states, try pressing the
key a few
times. If the login prompt still does not appear, write down the state
displayed on the LCD then see the troubleshooting procedures for
terminal connections in
DEFINITY AUDIX System — Maintenance ,
585-300-110.
4. For CL integration, proceed to Task 8: Install the Control-Link Cable. For
DS integration, proceed to Task 9: Install the Printer (Optional).
RETURN