Lucent Technologies CAJUN P332MF, Руководство пользователя

Страница: 85 / 134

Chapter 6 Cajun Campus CLI – Layer 2
Cajun P332MF User’s Guide 71
Example:
This example shows how to add a default route to the IP routing table:
Cajun_P330-N# set ip route 149.49.42.54 149.49.42.200
destination = 149.49.42.54 gateway = 149.49.42.200
ROUTE NET TABLE
destination gateway flags Refcnt Use Interface
------------------------------------------------------------------------
149.49.42.0 149.49.42.205 1 1 3199 se0
127.1.1.0 127.1.1.1 1 8 7606 se1
------------------------------------------------------------------------
ROUTE HOST TABLE
destination gateway flags Refcnt Use Interface
------------------------------------------------------------------------
127.0.0.1 127.0.0.1 5 2 131 lo0
149.49.42.54 149.49.42.200 7 0 0 se0
------------------------------------------------------------------------
Set snmp trap Commands
Use the
set snmp trap
commands to add an entry into the SNMP trap receiver
table and to enable or disable the different SNMP traps for a specific receiver. First
add the
rcvr_addr
and then enable/disable the different traps for it.
The syntax for this command is:
set snmp trap <rcvr_addr>
set snmp trap <rcvr_addr> {enable|disable} {all|config|fault|...}
enable Activate SNMP traps
disable Deactivate SNMP traps
all (Optional) Specify all trap types
config (Optional) Specify the ConfigChange trap from the TRAP-MIB.
fault (Optional) Specify the Fault trap from the TRAP-MIB.
rcvr_addr IP address or IP alias of the system to receive SNMP traps