ARRAY DC Fan Installation Instructions
13 |
P a g e
REPAIRING THE REMOTE & RECEIVER PAIRING – WHEN 1 CEILING FAN IS INSTALLED
•
If the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired.
•
Below are the operating symptoms and the steps to repair the pairing of the remote and receiver.
Symptoms:
•
Loss of control - Fan is only running at high speed after installation
•
Loss of control - No reverse function after installation
•
Loss of control - Remote cannot communicate with the receiver
Repairing Steps:
•
Switch OFF the main power to the ceiling fan for 30 seconds.
•
Switch ON the main power of the ceiling fan. Follow the same process as described in the ‘Paring remote
& receiver’ section to repair the pairing.
•
Turn on and select the different speed of the ceiling fan to check the operation of the fan.
AFTER INSTALLATION
NOTE
: Ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet.
If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres
is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE:
Please check that all screws which fix the mounting bracket and down rod
are secure.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-
hour “settling-in” period, most noises associated with a new
fan disappear during this time.
The man
ufacturer’s warranty covers actual faults that may develop and NOT minor complaints such as hearing
the motor run
– All electric motors are audible to some extent.
