ARRAY DC Fan Installation Instructions
12 |
P a g e
Remote / Receiver paring for Ceiling fan 2:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
•
Press and hold the “
” button of
remote 2
for 3-5 seconds within 30 seconds of switching the power ON
to the receiver of ceiling fan 2.
•
There will be a notification ‘beep’ sound from the receiver to indicate that the paring process is successful.
•
Turn ON the fan and change the speed of ceiling fan 2 by the remote to check the operation and
successful pairing.
•
If pairing has been unsuccessful, repeat these set of steps again
REMOTE CONTROL (Fig. 15)
The LED globe has a 3-step dimmable function which is controlled by an ON/OFF switch.
When the LED light is ON and at 100% brightness, press the light button “ON and then OFF within 3 seconds”,
to dim the LED light. Repeat pressing ON and then OFF within 3 seconds to dim further in the following
sequence:
100% brightness → 50% brightness → 15% brightness → 100% brightness.
The remote has memory function. If the fan or light is turned off by the isolating switch over 7 seconds, the
next time to turn on the fan or light will be on last setting
Fig. 15
(1)
Reverse control
(2)
Natural wind (The fan speed automatic cycle
between 1 to 6 speed)
(3)
Speed control
(4)
Light On/Off
(5)
Fan On/Off
(6)
1.5V AAA battery x 2 pcs (Included)
