ARRAY DC Fan Installation Instructions
11 |
P a g e
USING YOUR CEILING FAN
NOTE: The remote and receiver will need to be paired after the installation of the ceiling fan.
NOTE: When two or more ceiling fans are installed in one location, please refer to the
instruction on the next page.
PAIRING REMOTE & RECEIVER – WHEN 1 DC CEILING FAN IS INSTALLED IN ONE LOCATION
NOTE:
Ensure that you have installed a single pole disconnection switch in the fixed wiring for the fan.
NOTE:
Ensure power to the receiver is ON prior to pairing the remote with the receiver.
•
Turn OFF the mains supply to the fan by on/off wall switch.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to the receiver.
•
Press and hold the
button on the remote for 3-5 seconds within 30 seconds of switching the power
ON to the receiver of the ceiling fan.
•
There will be a notification ‘beep’ sound from the receiver to indicate that the paring process is successful.
•
Turn ON the fan and change the speed of the ceiling fan via the remote to check the operation and
successful paring.
•
If pairing has been unsuccessful, repeat these set of steps again
PAIRING REMOTE AND RECEIVER – WHEN 2 OR MORE DC CEILING FANS ARE INSTALLED IN ONE
LOCATION
When two or more ceiling fans are located near each other, you may desire to have the remote/receiver for
each fan paired so that the operation of one fan does not affect the operation of the other fans.
NOTE:
Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE:
Ensure power to the Receiver is
ON
prior to pairing the remote with the receiver.
Remote / Receiver pairing for ceiling fan 1:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the remote will be ON).
•
Press and hold the “
” button of
remote 1
for 3-5 seconds within 30 seconds of switching the power ON
to the receiver of ceiling fan 1.
•
There will be a notification ‘beep’ sound from the receiver to indicate that the paring process is successful.
•
Turn ON the fan and change the speed of the ceiling fan 1 by the remote to check the operation and
successful paring.
•
If pairing has been unsuccessful, repeat these set of steps again
