Grenada Installation Instructions
6 |
P a g e
V3.0- EN– Published on
10. 2019 (Separate earth)
ASSEMBLYING THE FAN
Install the down rod to the motor (fig. 4)
1.
Loosen the hanger ball via the set screw. (see Fig.4)
2.
Feed the down rod through the canopy.
3.
Insert the motor wires through the down rod, and then
secure the hanger ball back to the down rod.
4.
Insert the down rod to the coupling, line up the coupling
holes with the down rod holes and insert the bolt. Then
insert the pin to end of the bolt.
5.
Finally secure the down rod and coupling by tightening two
set screws on the coupling.
Blade attachment (Fig. 5 & Fig. 6)
1.
Assemble the blades and blade bracket together using the blade bracket / blade screws set. (Fig. 5)
2.
Remove the blade mounting screws and spring washer from the motor, and remove the plastic spacer
locking the rotating part of the motor from moving during transpotation.
3.
Secure the blade assembly onto the motor by tightening 2 screws with spring washers. Ensure all screws
are tightened envently to reduce the chance of warping or unbalancing. (Take care not to over tighten as
this can damage blades). Repeat the process on remaining blades. (Fig.6)
Fig. 4
Fig. 6
Fig. 5