Top climate system
with LUBING Touch Controller
Copyright © Lubing System - All rights reserved
16
4.3 Installation of additional modules
The pressure relief module for connection to the connection pipe
(art. 7113)
is
mounted between the hydraulic hose of the pump unit and the connection pipe. For
the connections of the T-piece, the information in chapter 3.5.2 “Cutting ring fittings”
must be observed. The mounting position of the valve should be with the solenoid
upwards. The hose at the connector should be led into the drain. The cable of the
valve connector is connected to the Touch Controller according to the specifications
in the chapter 7 “Wiring plans”.
The additional module 2-house without pressure relief
(art. 7114)
is mounted near the
pump unit on a wall or alternatively in the pump unit on the rear wall of the angle plate.
The mounting position of the valves should be with the solenoids pointing upwards.
The connector between the valves is connected to the hydraulic hose of the pump
unit. The two hydraulic hoses behind the valves are connected to the connecting
pipes to the two compartments. The cable of the double valve connector is connected
to the Touch Controller according to the specifications in the chapter 7 “Wiring plans”
(version
LC-2
or
LCS-2
required!).
The additional module 2-house with pressure relief
(art. 7115)
is mounted near the
pump unit on a wall or alternatively in the pump unit on the rear wall of the angle
plate. The mounting position of the valve block should be with the solenoids pointing
upwards. The right connection (P) is connected to the hydraulic hose of the pump unit.
The hose at the nozzle (R) is led into the drain. The two hydraulic hoses behind the valve
block (A1 and A2) are connected to the connecting pipes to the two compartments.
The cables of the double valve connectors are connected to the Touch Controller
according to the specifications in the chapter 7 “Wiring plans” (version
LC-2
or
LCS-2
required!). The two valves at the inlet of the valve block control the two outputs. The
two valves at the block outlet each serve as pressure relief.
IMPORTANT INFORMATION
The hoses must be installed in such a way that they cannot rub against other components/sharp edges.
The hoses must not be bent too much. Non-observance will reduce the lifetime of the hose.
NOTE
All protective conductors of the modules must be connected to the protective conductor terminal in the
touch controller. The multicore cables must be connected according to the wire colors in the chapter 7
“Anschlusspläne/Wiring plans”. For the double valve connectors of the 2-house modules, the position of
the respective connectors must be taken into account (compare the function of the valves in the wiring
plans).
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
