INTENDED USE
Oil preset meter can be used to dispense motor oil. With the pre-selected function, the nozzle
automatically closes the valve and stops dispensing.
TECHNICAL DETAILS
* Tested with DTE-25 motor oil at ambient temperature. Min.-Max. flow range will vary with fluid viscosity.
FACTORY SETTINGS
• Each meter is preprogrammed and calibrated at the factory. Unless otherwise specified at the
time of order, each meter is programmed in quarts for use with motor oil as standard. The
meter is shipped in the Manual Mode.
• The factory preset cannot be changed; if special requirements are needed, please contact an
authorized service center.
TOOL USE
• DO NOT modify or alter the meter.
• DO NOT leave the meter unattended while dispensing.
• Check the meter daily. Worn or damaged parts should be repaired or replaced immediately.
• DO NOT exceed the maximum working pressure level of the lowest rates system component.
• Use only extensions and nozzles that are compatible with this meter.
• Use only fluids and solvents that are compatible with the equipment. Notice the warnings for
fluids and solvents.
• Tighten all fluid connections before operating the meter.
• Comply with all local, state, and federal fire, electrical and safety regulations.
• Use of the product in a manner other than specified in this manual may result in bodily injury
or impaired operation or damage to the meter.
Item No.
Flow Range
Operating Pressure Range
Operating Temperature
Accuracy
Viscosity
5-Digital LCD Display (3/8"H x 3/16"W)
Inlet Connection
Power Source
0.3-9.2 GPM
7-1000 PSI
Max. 140°F
±0.5%
8-5000 mPas
Quart, Pint, Gallon, Liter
1/2"
1 Alkaline cell 9V
1813351
E1
TECHNICAL
DETAILS
INTENDED USE
FACTORY SETTINGS
TOOL USE
EXPLODED AND
PARTS LIST
OPERATION
TROUBLE
SHOOTING GUIDE
