LT LTC-0005A, Руководство пользователя

Страница: 13 / 39

Zhengzhou Linghang Robot Co.,Ltd
10
Warning: pneumatic fittings and pipelines must be able to
withstand repeated movements of the application without failure.
The wiring of electrical and pneumatic lines must minimize the
possibility of over stress, pull-out or kink. Failure to do so may result in critical
electrical or pneumatic pipeline failure and may result in personal injury or
equipment damage.
Warning: do not use a washer under the head of the mounting screw, and
do not let the mounting screw protrude above the mating surface of the
master plate and the tool plate. If the mounting screw protrudes above the
mating surface, a gap will be formed between the master plate and the tool
plate, resulting in the failure of the locking mechanism to fully engage,
which may cause equipment damage or personal injury. The mounting
screws must be flush or below the mating surface of the master plate and
tool plate.
Note: in the design of adapter flange and tool flange plate,
the positioning criteria of masterplate and adapter flange and the
positioning criteria of tool plate and tool flange shall be followed.
Otherwise, the connection may be loose;
Note: after the connecting screw uses the thread fastening
glue, if it is removed and reused, the thread fastening glue shall be
applied again.Otherwise, the screw may become loose. Always use
new thread locking compound when reusing fasteners.
The screw must be lower than
the mating surface of the
master plate and tool plate.