————————————————
Accessories from
—
The Original
——
Rev. 00 09/10/2012
Page 3 of 4
Now you should check the clearance to the tank and faring, therefore you have to mount all
controls provisorily on the handlebar.
Brake cylinder and clutch bracket need to be mounted
with a gap to the other controls (see picture below).
Fit the brake-fluid reservoir with new
bracket and M6x25 on the master cylinder.
Assure (without brake pressure) whether the brake lever can be pulled up to the grip and
doesn’t contact any other parts before.
Instruction for rerouting cables hoses and wiring harness:
Throttle cables (1):
Reroute behind the
slider-tube. Check throttle cables for free
movement on every steering angle.
Brake hose (2):
Mount the manifold with
M6x25 on the top yoke (view picture for the
alignment). Then fit the original brake hose on
the manifold from underneath and the new
hose with the straight fitting on the front. Then
connect the bended fitting to the master
cylinder, as shown.
Mind the mounting
instructions that are delivered with the
brake hose.
Clutch cable (3):
Route clutch cable through
the top yoke’s hole and behind the brake
hose.
Right wiring harness (4):
Reroute harness
behind the slider-tube.
10mm
15mm
bracket
& M6x25
Original bolt with self-
locking nut M5 and washer.
1
2
3
4
