LSI Mylex PCI Disk Array Controllers Driver, Руководство по установке

Страница: 16 / 104

Installing the Controller as the Primary NetWare 4.2 Controller
2-2 PCI Disk Array Controller Drivers Manual
Installing the Controller as the Primary
NetWare 4.2 Controller
If you are installing NetWare 4.2 for the first time, you will not be able to
install the controller driver, MDACFSI.HAM to put the SYS volume on the
Mylex controller. Service Pack 9 (SP9) is required to install this driver and
must be installed after NetWare 4.2 is installed.
To install the Mylex controller as a primary (bootable) controller, you will
need a secondary controller (IDE or SCSI) with a disk drive to temporarily
hold the SYS volume. Follow these procedures and, if necessary, refer to
Novell’s documentation for assistance. This procedure assumes the user is
familiar with creating volumes in NetWare.
1. Install the boot DOS partition on the Mylex controller.
2. Install NetWare 4.2 and place the SYS volume on the secondary
controller. NOTE: If your CD-ROM drive is attached to the Mylex
controller, select the DOS drive letter of the NetWare 4.2 CD-ROM
when asked for the installation path.
3. Install SP9.
4. Install and load the MDACFSI.HAM driver.
5. Load the INSTALL.NLM utility.
6. Create volume SYS1 on the Mylex controller.
7. Copy the SYS volume from the secondary controller to SYS1 on the
Mylex controller.
8. Back up NDS to the C: drive. From the Installation Options choose:
Directory options | Directory backup and restore options | Save local
DS information prior to hardware upgrade.
9. Rename SYS volume to SYS2 on the secondary controller.
10. Rename SYS1 to SYS on the Mylex controller.
11. Restore NDS from the C: drive. From the Installation Options choose:
Directory options | Directory backup and restore options | Restore local
DS information after hardware upgrade.
You have completed setting up the Mylex controller as a primary controller.
Continue with your server installation setup procedures. The secondary
controller with its disk drive is no longer needed and can be removed or used
for other applications.