R-Log – Quick Start
Cod. INSTUM_00953
Pag. 3
1.
Introduction
This manual is an introduction to the use of the R-Log datalogger.
Reading this manual will allow you to perform the basic operations for starting this device.
Refer to
GidasTea – User manual
(code SWUM_00662) and particularly to the
Step-by-step Guide
accessible from
?
menu of GidasTEA program for applications requiring the calculation of
microclimate indexes.
For special applications, such as - for example – the use of specific communication devices (modem,
communicators, Ethernet/RS232 converters etc.) or where the implementation of actuation logics or
the setup of calculated measurements is requested, please refer to the R-Log and
3DOM
software
User Manuals, that are included in the
MW6501 - LSI LASTEM Products
DVD
in the
Manuals
–
DOCUMENTS
section.
2.
To start…
There are the following models of R-Log:
Model
Connector
inputs
Terminal
board
inputs
Master
mode
Repeater
mode
Slave
mode
Ethernet
output
ELR510M
X
-
X
-
-
-
ELR510R
X
-
-
X
-
-
ELR510S
X
-
-
-
X
-
ELR515M
-
X
X
-
-
-
ELR515R
-
X
-
X
-
-
ELR515S
-
X
-
-
X
-
ELR516M
-
X
X
-
-
X
Additionally, R-Log is compatible with the following sensors provided with radio communication
(S-Log):
o
ELR200
: environment sensors for temperature/ relative humidity;
o
ELR205
: black globe and wet bulb temperature sensors;
o
ELR210
: 2- temperature contact sensor.
The instrument model is indicated on the label located on the back of the instrument and in the
information displayed by the datalogger during the first boot phases (§3.2.1).
3.
First installation
Basic operations for turning the instrument on depend on the installation typology to be
implemented: from the simplest, consisting of a single Master datalogger (Fig. 1), to the more
complex, consisting of a Master instrument and of one or more Slave/Repeater devices (Fig. 2 and
Fig. 3).
