Attach or detach the implement on wide and level
ground.
Do not stand between tractor and implement.
Use hitch or drawbar for towing. Do not tow by
connecting with any other structures.
When connecting heavy implements, apply the
parking brake and use the wheel chock.
Do not attach over-weighted implement.
(4) Notices when connecting Implement
▶
When connecting or disconnecting hydraulic coupler, lower implement on the
ground, turn off engine and check if the pressure of hydraulic line is released.
Caution
(5) Notices when towing the tractor
▶
Before connecting or checking the implement, put PTO switch to OFF position and
place PTO gear lever in Neutral position.
▶
When attaching or detaching the implement, make sure to fix the implement and
tighten the three point hitch pins correctly. If not, serious troubles and injury can
occur during the operation.
▶
If heavy loaded trailer is connected to 3-point linkage or any structure, it can cause
turnover or failure and serious injury. Make sure to use towing hitch or authorized
draw bar.
Warning
▶
When installing the implement having big hydraulic cylinders or lines, check oil
level in tractor transmission housing after installing the implements.
Caution
If tractor needs to be towed for a short distance,
Use the hitch (or drawbar) or front towing hook.
Do not connect to other structures such as rear
axle, ROPS, front axle, steering components for
1
1
1
1
- 8
Check the horizontal and vertical permissible load of the hitch (or drawbar) before towing. The load
is different with trailer brake, and stopping distance increases with speed and weight of towed loads
and slope. Make sure you consider the total weight of the equipment and its load. (
See page 4-16
)
axle, ROPS, front axle, steering components for
towing.
Tractor can be steered for a short distance
without engine running, but it will be hard to turn
the steering wheel. If possible, run the engine for
steering and lubrication.
When being towed, disengage the 4WD,
differential lock, parking brake and place all gear
shift levers in neutral position. Refer to “3-2.
Operating levers and pedals”.
(See page 3-7)
