Maintenace ProtoMat S-Serie
4 / 9
•
Remove the two marked screws (Torx 27), and pull the cover plate to the front and out of the
machine.
•
Use the brush once more to pick up some ball bearing grease, and apply grease to the linear guides (2
and 3).
•
Clean the brush thoroughly. Then use the same brush to pick up some plastic nut grease, and smear
some grease onto the transport spindle in the vicinity of the spindle nut.
•
Replace the cover plate and make sure that the two positioning tabs sit properly in the back of the ma-
chine housing. The two positioning tabs are visible when you look through the opening at the back of the
housing. Once properly in place, screw in the two screws again.
•
Now run the table to and fro a few times to spread the grease properly.
