Maintenace ProtoMat S-Serie
3 / 9
•
Close the cowling of the cross member and the hatch in the cover, and run the head of the miller 310 mm
to the right with the BoardMaster.
•
Open the hatch and use the brush to smear some plastic nut grease onto the transport spindle to the left
of the spindle nut.
•
Clean the brush thoroughly.
•
Now pick up some ball bearing grease with the cleaned brush, and brush it onto the upper linear guide (2)
and the lower linear guide (3).
•
Close the cowling of the cross member and the hatch in the cover, and run the machine to the 0 position.
•
Reopen the hatch in the cover and the cowling around the cross member, and use the brush again to
apply some ball bearing grease to this side of the linear guides (2 and 3).
•
Close the cowling around the cross member again and fix back in place with the pins. Close the cover,
and run the milling head 310 mm back to the right, and then return it to the 0 position. This spreads the
grease uniformly over the transport spindle and the linear guides.
•
Make sure that the head is in the 0 position.
•
Open the hatch in the cover, and remove the cover on the front of the machine (A).
