Lowrance GlobalMap Baja 840C, Руководство по эксплуатации

Страница: 85 / 164

77
To get to the GPS Simulator:
1. Press
MENU
|
MENU
|
↓
to
S
YSTEM
S
ETUP
|
ENT
.
2. Press
↓
to
S
IMULATORS
|
ENT
. The GPS Simulator Menu appears.
3. Press
↓
to
GPS S
IMULATOR
O
N
| ENT
GPS Setup Menu (left); GPS Simulator menu (right).
Make the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
O
N
box and pressing
ENT
key. Press
EXIT
|
EXIT
|
EXIT
to clear this menu. A message and tone appear periodically, warning
you that the simulator is on. To turn the simulator off, repeat the above
steps or turn off the unit.
While in simulator mode, you can press
EXIT
to clear the steering and
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, select
the
S
TEER WITH
A
RROWS
command, press
ENT
, then press
EXIT
|
EXIT
|
EXIT
to
return to the previous page.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. Go to the simulator menu as shown above. Pick a
S
TARTING
P
OSITION
at or
near the beginning of your trail/route. Enter an approximate
T
RACK
(shown
in compass degrees) that will point you toward the start of the trail/route.
2. Set
S
PEED
to zero. Select
S
TEER WITH
A
RROWS
command and press
ENT
,
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
EXIT
to clear the alarm.). When navigation starts,
press
↑
to increase speed to the desired setting.