Lowrance Active Imaging 3-IN-1, Руководство по установке

Страница: 16 / 24

Jackplate mount supplies (not included)
6 mm (1/4”) Drill bit (Jackplate
Mount) M6 (1/4”) jackplate mount bolts
Warning: Before installing the transducer on the
jackplate, lower the jackplate to its lowest setting to
make sure there is enough clearance between the
jackplate, engine, transom, and the transducer. Lack of
clearance could damage the transducer when the
engine is all the way down.
1.
Attach the bracket mount plate to the transducer using the 6
M4 attachment screws and M4 lock washers. Do not attach the
transom mount plate to the transducer bracket mount plate at
this time.
2.
Choose a transducer location on the inside or outside of the
jackplate.
3.
Adjust the jackplate up and down to make sure the transducer
will not obstruct jackplate movement.
4.
Make sure nothing blocks the sonar beam on either side of the
transducer.
5.
Move the transom mount plate into the desired position and
use a pencil to mark the holes through the hinge hole and the
top hole in the side of the bracket.
6.
Using a 6 mm or equivalent drill bit, drill the holes into the
jackplate.
7.
Depending where you want to mount it on the jackplate, slide
the transom mount plate inside the jackplate or hold it on the
outside of the jackplate and align the bracket holes with holes
you drilled in the jackplate.
8.
Slide the M6 bolt into the top hole on the side of the jackplate
and the top hole of the transom mount plate.
9.
Attach the M6 nut to the end of the bolt and tighten the nut.
10.
Route the cable between the bracket mount plate (holding the
transducer) and the transom mount plate.
11.
Hold the transducer mount plate (which is attached to the
transducer) so the bottom transom mount plate holes, the
hinge holes of the bracket mount plate (holding the transducer),
and the bottom holes you drilled in the jackplate are aligned. Be
16
Installation | Active Imaging transducers Installation
Manual