Lowrance Active Imaging 3-IN-1, Руководство по установке

Страница: 12 / 24

Step mount using the transom bracket
The transducer can be mounted on a transom bracket. With this
mounting option the transducer can be in the water when you are
on plane, or can be mounted so it is only in the water when you are
moving at trolling speed.
Ú
Note:
Sonar does not track bottom when the transducer is out
of the water.
1.
Attach the transducer to the bracket mount plate using the 6
M4 attachment screws and M4 lock washers.
2.
Loosely attach the transducer bracket mount plate to the
transom mount plate using M6 screws and nuts. Be careful to
run the cable between the bracket mount plate and the
transom mount plate before inserting the screws.
3.
Choose a transducer location.
4.
Move the transducer bracket into the desired position and then
use a pencil to mark the pilot holes through the slots in the
transom mount plate.
5.
Drill the pilot holes.
6.
Apply a marine high-grade above- or below-waterline sealant/
adhesive compound to the pilot holes.
7.
Align the transom mount plate screw slots over the pilot holes
and fasten the bracket to the transom using the supplied
screws.
8.
To make adjustments to transducer position, loosen the screws
and slide bracket up or down.
9.
Set the angle of the transducer and tighten the M6 screws that
attach the transducer bracket mount plate to the transom
mount plate.
10.
Route the transducer cables through the bracket to the location
where the display or sonar module is installed.
12
Installation | Active Imaging transducers Installation
Manual