DISPLAY BIGSTONE C600E
You can switch on/switch off the power supply
of the e-bike motor by pressing the
button (
right,
in the centre of the control panel) for a few seconds.
The motor assistance level
PAS (0–5) is displayed
in the lower left corner (5 = highest, 1 = lowest,
0 = without any assistance). You will increase the
motor assistance level by briefly pressing the
+
button
(
top of the control panel). You will decrease the
motor assistance level by briefly pressing the
–
button
(
bottom of the control panel).
The charge indicator (battery symbol in the upper left corner of the display) shows
the charge level: 5 bars = the battery is charged > 80 %, 1 bar = the battery is charged
< 20 %.
Charge the battery as soon as possible if it indicates just one bar.
Please contact your dealer in case of
an error message
Error
(upper left corner
of
the
display).
Current speed is displayed in the centre of the display (
KM/H).
The parameters mentioned below are stated in the lower right corner of the display:
ODO = total mileage; TIME = duration of the ride (it is automatically reset after the
display is turned-off); TRIP1 = trip mileage; TRIP2 = trip mileage (it is automatically reset
30 s after the display is turned-on). You can switch between individual parameters by
briefly pressing the SET button (
left, in the centre of the control panel).
RESETTING: TRIP1 parameter can be reset (it is automatically reset after 500 km). Press the „SET“
button until there is „0“ displayed in the lower left corner. Then briefly press „SET“, so there is „1“
displayed in the lower left corner and „TRIP1/TRIP2“ in the lower right corner. Reset the TRIP1 by briefly
pressing the „–“ button. You will return to the default data display by pressing the „SET“ button
for a few seconds.
The display back-light, front and rear lights can be turned on/turned off by briefly pressing
the
button (
right, in the centre of the control panel). It will be shown on the display as
a
picture.
By pressing the
–
button (
bottom of the control panel) you will activate the walk assistance
and the e-bike will move at the speed of 4–6 km/h (displayed as 6KM in the centre
of the display). By releasing the
–
button you will deactivate the assistance. The walk
assistance facilitates control of the e-bike (for example when pushing the e-bike uphill).
This function is to be used only for the e-bike control (pushing), not when setting off or riding!
The display will be deactivated after approximately 5 minutes of inactivity.
The display cover is made from ABS plastic, which ensures durability for common use.
Do not expose the display to temperatures below –20 °C and above 60 °C.
