OPERATION STEPS
Turn on the system: Set the ON/OFF switch
○
14 to the ON (I) position. Screen will turn on
and will show the current volume after 5 Seconds.
Set the operation mode switch
Use the operating mode switch to select the type of work you want to perform.
For cutting expanded metal, grates, metal
containing holes, or any job that requires a
continuous pilot arc. Using this mode to cut standard
metal plate will reduce consumable life.
For cutting or piercing metal. This is the standard
setting for normal metal cutting.
For gouging metal. (Note: there are no gouging
consumables in the box. For plasma air gouging you
will need to buy the gouging consumables set
separately.)
For setting post flow, then you can adjust the
knob set the post flow time. When the digital display
does not flash, the setting is complete and the setting
will be saved automatically.
Set the 2T/4T model switch
2T/4T Locks the torch in the ON (fire) position.
With the 4T option selected, press the trigger to fire
the torch. You can then release the trigger while
continuing to cut. Press the trigger again to stop the
arc. The arc also stops if you lose transfer.
Adjust the air flow
Set the mode switch to Gas Check/Post Flow mode.
