41
Using the Main Menu
Alarm
The Alarm tab allows you to
configure Motion Detection
settings.
Configuring Motion Detection
Configure motion settings to determine
the area you wish to monitor for motion
events, and the outcome if a motion
event occurs.
To configure motion settings:
1
Select the
Motion
tab.
2
Configure the following:
•
Channel:
Select the channel you wish to
configure.
•
Enable:
Select
Enable
or
Disable
to
activate or deactivate motion recording.
•
Area:
Click the
Setup
button to configure
the area of the screen that detects motion.
•
Sensitivity:
Select motion sensitivity. The
greater the number, the greater the
sensitivity.
•
Show Message:
Select the checkbox if you
want the system to display a system
message when an alarm triggers.
•
Buzzer:
Select the duration the system
will "beep" when motion is detected. Or
select
OFF
to disable the "beep" during
motion events.
•
Send Email:
Select the checkbox if you
want the system to send email
notifications if an alarm triggers. Email
notifications must be configured.
•
Record Channel
: Select the channel you
wish the DVR to record during motion
recording.
•
Full Screen:
Select the
Full Screen
check
box so that the system goes into full screen
mode when motion is detected.
•
Post Recording
: Enter the post recording
duration (the time the system continues to
record after a motion event occurs).
3
Click
Apply
to save your settings.
Drag mouse cursor
over desired area
Click and drag the mouse cursor to configure motion
detection areas. Motion detection is enabled in red areas
and disabled in transparent areas. Right-click to exit.