1.CO NT R OLS AN D FU N CTIONS
WIRELESS CCD CAMERA
1. LENS
1/3" B/W CCD Image sensor with
built-in 92
°
fixed wide-angle lens.
2. MICROPHONE
Built-in condenser microphone.
(one-way audio)
3. LED-POWER INDICATOR
Indicates that the camera is turned on.
4. 2.4 GHz A/V ANTENNA
High gain directional patch antenna
sends A/V signal to the receiver.
5. STAND MOUNTING SOCKET
Reinforcement lock for camera stand.
6. CHANNEL SELECTOR SWITCH
Switch for the channel 1-2 selection.
7. POWER SWITCH ON/OFF
Controls power. Be sure to set the
switch to off position before plugging the
AC adapter into the unit and AC outlet.
8. AUDIO/VIDEO OUT JACKS
EAR Audio/Video-Out jacks for wire
mode operation.
9. DC IN JACK
Plug the 12V(500mA) AC Adapter in here.
REAR VIEW
FRONT VIEW
4
2
3
1
5
7
6
8
9
5
12
VCR Rear
3.SYSTE M OPE RATION
OPERATION WITH MONITOR & VCR
Both Camera and Receiver Monitor units must be set to same channel.
NOTE
NOTE
Be sure to set the Power Switch on both the Receiver Monitor and Camera
to the OFF position before proceeding with the following steps.
NOTE
RCA Cable (1)
Camera
(1) Connect supplied power adapter to Camera power input.
(2) Slide the channel selector switch to CH 1~2 of your choice.
Receiver Monitor
(1) Connect supplied power adapter or plug from Battery Case to Receiver Monitor
power input.
(2) Search the channel 1-2 by using Channel Selector Switch on the Receiver Monitor and
Camera and select best one for optimum reception in your area.
(3) The fine tuning knob should be kept in the center position for best reception.
(4) Try to position both the Camera and Monitor as high off the ground as possible for
better reception.
(5) Connect A/V output signal to your VCR recorder. If you want to record the camera signal.
(6) Volume Control--Adjust the knob for desired volume level.
(7) Bright and Contrast Control--If the picture is too bright or too dark, adjust the bright
and contrast controls to suit.
(8) Vertical Hold Control--If picture rolls up and down
(as illustrated) adjust the vertical hold control.
(9) Adjust the antenna direction as necessary.
Receiver Monitor
12-14V 1.2A
AC Adapter
or plug from
Battery Case
Video Output Jack
Audio Output Jack
DC Input
Jack
Channel Selector
Switch
Contrast Control
V-Hold Control
Bright Control
