Lorex RV453, Инструкция по эксплуатации

Страница: 10 / 16

10
Monitor Installation
Monitor Installation
1. Determine the location to mount the monitor. Install the monitor mounting bracket by placing the
screw into the center hole. Rotate and adjust the bracket by turning it left and right for the best
placement. Screw in the slide holes on the bracket and tighten the screws.
2. Mount the monitor onto the bracket by using the supplied screws. Adjust the monitor up and
down to the best position and tighten the screws.
3. If necessary attach the sun shield on top of the monitor.
Connecting the Monitor and Cables
1. Connect the cameras to the camera input sockets marked C1 and C2 on the back of the monitor.
NOTE: Connect the backup (reverse gear) camera into the C1 (camera 1) port.
2. Plug the power harness into the socket marked POWER at the back of the monitor.
Connecting the Monitor Power
The diagram below outlines the connections for the power cable:
NOTE : The Red wire with the fuse holder should be connected to vehicle ACC Terminal; the
Brown wire to reverse gear relay; and the Black wire to the chassis ground.