Lorex N881 Series, Руководство пользователя, Страница: 91 / 136

Using the Main Menu 16
2. Click , then click EVENT . Click the MOTION tab on the side panel, then click
the
Video Loss
tab on the top panel.
3. Under Camera , select the channel you would like to configure.
4. Check
Enable
to enable video loss events for the selected channel.
5. Configure the following to customize settings for video loss events:
•
Alarm Out:
Check the box to activate alarm output devices (not included) when the se-
lected channel loses video. Select the alarm output devices that will be activated when vid-
eo loss occurs, then enter the number of seconds the alarm output device(s) will activate
after video loss occurs next to
Latch .
• Schedule: Click Set to configure a schedule for video loss events. It is recommended to
leave this on the default setting, so you can be alerted at any time one of your cameras loses
video.
•
Show Message:
Check to show a popup message on the monitor if one of your cameras
loses video.
•
Send Email:
Check to enable email alerts. You must configure email alerts before you will
be able to receive them (see 16.4.4 Configuring Email Alerts , page 78).
• Record Channel: Click the checkbox to enable video recording when video loss occurs.
You can then select the channels the system will record when video loss occurs on the cur-
rently selected channel.
•
PTZ Activation:
Check to enable PTZ actions when video loss occurs (PTZ camera re-
quired; not included). Click Set to select which PTZ actions will be taken by each camera.
•
Post_REC:
Enter the number of seconds the system will record after video loss occurs.
• Sequence: Check to enable a custom sequence mode when motion is detected on the se-
lected channel. Then click the channels you would like to display in the custom sequence
mode.
• Snapshot: Click the box to enable snapshot recording when video loss occurs. You can
then select which channels will save snapshots when video loss occurs on the currently se-
lected channel.
•
Buzzer:
Check to enable the system buzzer when video loss occurs on the currently se-
lected channel.
6. Click
Apply
to save changes.
#LX400113; r. 3.0/56326/56332; en-US 83