Hard Drive Replacement - Appendix #3
31
Hard Drive Replacement - Appendix #3
The DVR comes with a pre-installed Hard Drive; however the unit will work with a replacement single IDE
Hard Drive (up to 500GB).
NOTE
: Make sure that the DVR is OFF and the power cable has been disconnected before changing the
Hard Drive.
Removing the Back Cover and Installed Drive
1.
Remove the seven (7) screws from the DVR
Cover. Remove the cover panel.
2.
Remove all cables from the previously installed
drive.
3.
Remove the screws holding the drive to the
case.
Setting the New Drive to Master
•
Refer to the General Jumper Pin Setting on HDD Surface (generally located on a sticker on the
top of the drive).
•
Set the Jumper Pin Set to Master (1 Drive).
NOTE
: Use an IDE Hard Drive.
