Lorex E861AB-E, Руководство пользователя

Страница: 10 / 122

Important Safeguards 1
6. Overloading: Do not overload wall outlets or extension cords as this can result in the risk of
fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged
or cracked wire insulation, and broken plugs are dangerous. They may result in a shock or
fire hazard. Periodically examine the cord, and if its appearance indicates damage or deterio-
rated insulation, have it replaced by your service technician.
7.
Power-Cord Protection:
Power supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them. Pay particular attention to
cords at plugs, convenience receptacles, and the point where they exit from the product.
8. Surge Protectors: It is highly recommended that the product be connected to a surge protec-
tor. Doing so will protect the product from damage caused by power surges. Surge protectors
should bear the UL listing mark or CSA certification mark.
9. Uninterruptible Power Supplies (UPS): Because this product is designed for continuous,
24/7 operation, it is recommended that you connect the product to an uninterruptible power
supply. An uninterruptible power supply has an internal battery that will keep the product
running in the event of a power outage. Uninterruptible power supplies should bear the UL
listing mark or CSA certification mark.
10. Ventilation: Slots and openings in the case are provided for ventilation to ensure reliable op-
eration of the product and to protect it from overheating. These openings must not be
blocked or covered. The openings should never be blocked by placing the product on a bed,
sofa, rug, or other similar surface. This product should never be placed near or over a radia-
tor or heat register. This product should not be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is provided and the product manufacturer’s in-
structions have been followed.
11.
Attachments:
Do not use attachments unless recommended by the product manufacturer as
they may cause a hazard.
12. Water and Moisture: Do not use this product near water — for example, near a bath tub,
wash bowl, kitchen sink or laundry tub, in a wet basement, near a swimming pool and the
like.
13.
Heat:
The product should be situated away from heat sources such as radiators, heat regis-
ters, stoves, or other products (including amplifiers) that produce heat.
14.
Accessories:
Do not place this product on an unstable cart, stand, tripod, or table. The prod-
uct may fall, causing serious damage to the product. Use this product only with a cart, stand,
tripod, bracket, or table recommended by the manufacturer or sold with the product. Any
mounting of the product should follow the manufacturer’s instructions and use a mounting
accessory recommended by the manufacturer.
15.
Camera Extension Cables:
Check the rating of your extension cable(s) to verify compli-
ance with your local authority regulations prior to installation.
16.
Mounting:
The cameras provided with this system should be mounted only as instructed in
this guide or the instructions that came with your cameras, using the provided mounting
brackets.
17. Camera Installation: Cameras are not intended for submersion in water. Not all cameras
can be installed outdoors. Check your camera environmental rating to confirm if they can be
installed outdoors. When installing cameras outdoors, installation in a sheltered area is
required.
1.3 Service
1.
Servicing:
Do not attempt to service this product yourself, as opening or removing covers
may expose you to dangerous voltage or other hazards. Refer all servicing to qualified serv-
ice personnel.
#LX400117; r. 6.0/57895/57895; en-US 2