TABLE OF CONTENTS
E 6
LOREME
12, rue des Potiers d'Etain - 57071 Metz
03.87.76.32.51 - Email: [email protected] - [email protected]
Visualization
In measure mode 2 information’s are displayed on screen every 2 seconds:
138.5 ohms
Measured resistance.
100.0 °C
Measured temperature.
Configuration
This manual resume in detail the different configuration possibilities.
To access the configuration mode, type the "
C
" key.
On the front face the following message is displayed:
CONF PAR RS232
RS232 CONF.
EN COURS...
IN PROGRESS
1) Method
In configuration, different types of questions are asked. For each of them, several answers are possible. Here is their
description:
1.1) Value acquisition
Example:
SEUIL?
80 °C
Two possibilities:
- The validation without modification by typing "
Enter
",
- The modification with simultaneous display followed by validation with "Enter" key.
2) Configurable parameters
The following parameters can be configured:
- The threshold (setpoint).
- The hysteresis.
- The delay.
2.1) Configuration messages
CONFIGURATION
REV:0.1
SEUIL?
Threshold setting (-50 °C to 250 °C).
80 °C
HYSTERESIS?
Hysteresis setting (0 °C to 50 °C).
2 °C
RETARD?
Relay activation delay setting (0 s to 300 s).
0.5 s
Terminal mode
Remarks:
- It is possible, when a mistake is made during a value acquisition, before validating it, to go back by pressing on
backspace key. This re-displays the message without taking notice of the mistake.
- In configuration mode, if there is no action on a key during 2 minutes, device goes back in measure mode without
taking notice of the modifications made before.
- In configuration mode, if you want go back to measure mode without taking notice of modifications made before,
just press the escape key.