Installation
(For Qualified Installers Only)
7
© Travis Industries
4141007
100-01402
Heating Specifications
Approximate Maximum Heating Capacity (in square feet)* ............................................ Up to 2,000 Sq. Feet
BTUs Per Hour ............................................................................................................... 13,940 to 49,200 **
Burn Rate (Pounds per Hour)*** .................................................................................... 1.7 to 6
Maximum Burn Time on Low Burn*** ............................................................................. 47 Hours
Hopper Capacity ............................................................................................................ 80 Pounds
Turn-Down Ratio ............................................................................................................ 72%
*
Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is
also affected by the fuel size, quality, and moisture level.
**
Based on 8,200 BTUs per pound.
*** Small pellet size will decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on
fuel quality may occur.
Dimensions
Electrical Specifications
Electrical Rating ...................................................................................................... 115 Volts, 4 Amps, 60 Hz
Watts during Start-Up Sequence ............................................................................ 480 (approximately)
Watts during Operation ........................................................................................... 300 (approximately)
Fuel
This heater is designed and approved for pelletized wood fuel only (all grades).
Emissions
This heater meets the 2015 U.S. EPA’s pelletized wood emission limits for pellet heaters sold after May
15, 2015. Tested to Method 28, 5G2 this heater has been shown to deliver heat at rates ranging from
12,100 to 41,100 BTU/hr and an emission value of 0.73g/h.
Efficiency
This model was not tested for efficiency however it is assigned a default efficiency of 78% by the EPA
under previous subpart AAA.
3" (77mm) Dia. Exhaust
(centered on appliance)
3" (77mm) Dia. Air Intake
5" (127mm)
25-1/2" (648mm)
26-1/2"
(674mm)
36"
(915mm)
45-1/2"
(1156mm)
Centerline of Air
Intake and Exhaust
WEIGHT: 340 lbs. (154 Kg)
9" (229mm)
